Orangepi RK3399

This tutorial will show the details of OrangePI RK3399 board mainline support.

Hardware details and wiki OrangePI RK3399

Hardware Access

BSP Build

Manual Build

ATF

::

$ git clone https://github.com/ARM-software/arm-trusted-firmware.git $ cd /path/to/arm-trusted-firmware $ make realclean $ make CROSS_COMPILE=aarch64-linux-gnu- PLAT=rk3399 bl31 $ cp /path/to/arm-trusted-firmware/build/rk3399/release/bl31/bl31.elf /path/to/u-boot

U-Boot

::

$ git clone https://github.com/amarula/u-boot-amarula $ cd u-boot-amarula $ git checkout -b rockdev origin/rockdev $ make orangepi-rk3399_defconfig $ make $ make u-boot.itb

Linux

$ git clone git://git.kernel.org/pub/scm/linux/kernel/git/next/linux-next.git
$ cd linux-next
$ make mrproper
$ ARCH=arm64 make defconfig
$ ARCH=arm64 make Image dtbs -j 4

Buildroot

::

$ git clone https://github.com/amarula/buildroot-amarula $ cd buildroot-amarula $ git checkout -b rockdev origin/rockdev $ make orangepi_rk3399_defconfig

SD Boot

Create Single partition and Insert the SD on host or use sdcard.img from buildroot.

$ cd /path/to/u-boot
$ ./tools/mkimage  -n rk3399 -T rksd -d spl/u-boot-spl-dtb.bin out
$ sudo dd if=out of=/dev/sdc seek=64
$ sudo dd if=u-boot.itb of=/dev/sdc seek=16384
$ sync

If board is always boot from eMMC, refer to RK3399 SD Boot Setup

Put this SD (or micro-SD) card into your board and reset it. You should see something like:

U-Boot SPL board init
Trying to boot from MMC1

U-Boot 2019.04-rc4 (Apr 22 2019 - 13:38:40 +0530)

Model: Orange Pi RK3399 Board
DRAM:  2 GiB
MMC:   dwmmc@fe310000: 2, dwmmc@fe320000: 1, sdhci@fe330000: 0
Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial@ff1a0000
Out:   serial@ff1a0000
Err:   serial@ff1a0000
Model: Orange Pi RK3399 Board
Net:   eth0: ethernet@fe300000
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0(part 0) is current device
** No partition table - mmc 0 **
switch to partitions #0, OK
mmc1 is current device
Scanning mmc 1:1...
Found /boot/extlinux/extlinux.conf
Retrieving file: /boot/extlinux/extlinux.conf
157 bytes read in 2 ms (76.2 KiB/s)
1:      OrangePi RK3399
Retrieving file: /boot/Image
20886016 bytes read in 943 ms (21.1 MiB/s)
append: earlycon=uart8250,mmio32,0xff1a0000 root=/dev/mmcblk1p1 rootwait
Retrieving file: /boot/rk3399-orangepi.dtb
55460 bytes read in 5 ms (10.6 MiB/s)
## Flattened Device Tree blob at 01f00000
   Booting using the fdt blob at 0x1f00000
   Loading Device Tree to 000000007df18000, end 000000007df288a3 ... OK

Starting kernel ...

[    0.000000] Booting Linux on physical CPU 0x0000000000 [0x410fd034]
[    0.000000] Linux version 5.1.0-rc1 (shyam@debian) (gcc version 7.4.0 (Buildroot 2019.05-git-00362-gcd58f3609b-dirty)) #2 SMP PREEMPT Mon Apr 22 13:39
:32 IST 2019
[    0.000000] Machine model: Orange Pi RK3399 Board
[    0.000000] earlycon: uart8250 at MMIO32 0x00000000ff1a0000 (options '')
[    0.000000] printk: bootconsole [uart8250] enabled
[    0.000000] efi: Getting EFI parameters from FDT:
[    0.000000] efi: UEFI not found.
[    0.000000] cma: Reserved 32 MiB at 0x000000007e000000
[    0.000000] NUMA: No NUMA configuration found
[    0.000000] NUMA: Faking a node at [mem 0x0000000000200000-0x000000007fffffff]
[    0.000000] NUMA: NODE_DATA [mem 0x7dba0840-0x7dba1fff]
[    0.000000] Zone ranges:
[    0.000000]   DMA32    [mem 0x0000000000200000-0x000000007fffffff]
[    0.000000]   Normal   empty
[    0.000000] Movable zone start for each node
[    0.000000] Early memory node ranges
[    0.000000]   node   0: [mem 0x0000000000200000-0x000000007fffffff]
[    0.000000] Initmem setup node 0 [mem 0x0000000000200000-0x000000007fffffff]
[    0.000000] psci: probing for conduit method from DT.
[    0.000000] psci: PSCIv1.1 detected in firmware.
[    0.000000] psci: Using standard PSCI v0.2 function IDs
[    0.000000] psci: MIGRATE_INFO_TYPE not supported.
[    0.000000] psci: SMC Calling Convention v1.1
[    0.000000] random: get_random_bytes called from start_kernel+0xa8/0x46c with crng_init=0
[    0.000000] percpu: Embedded 23 pages/cpu @(____ptrval____) s56664 r8192 d29352 u94208
[    0.000000] Detected VIPT I-cache on CPU0
[    0.000000] CPU features: detected: ARM erratum 845719
[    0.000000] CPU features: detected: GIC system register CPU interface
[    0.000000] Speculative Store Bypass Disable mitigation not required
[    0.000000] Built 1 zonelists, mobility grouping on.  Total pages: 515592
[    0.000000] Policy zone: DMA32
[    0.000000] Kernel command line: earlycon=uart8250,mmio32,0xff1a0000 root=/dev/mmcblk1p1 rootwait